Ahsoka hilt snag

I’ve been using the @starwarsrebels¬†supplied concept images of Ahsoka and found I’m only a tiny bit shorter than her, which sort of balances out if I wear orthotics in the boots, which is sensible, and can potentially just pad a little more between me and the headpiece.

(edit, this was supposed to be posted before my last post but well.. I mistake the “add tags” and “publish” buttons!)

So I decided I will scale to the appropriate height of her vs me as it won’t be so far off as to look like I’m carrying oversized versions.

But I want to eventually put a blade in. But even with a little rounding up to account for the blurring of the lines when scaled I wind up with a 20mm thickness. My Shaak Ti and Talon blades are 20mm. I find it mimics the OT and SWR style well while the 25mm (1″) blades often used really mimic the prequels and TCW.

What this means is I would want at least 24mm thickness. This is because there is an inset piece that should be at least 1mm. That gives me 1mm thickness around the blade- a bit close but my ventress hilts are that thin in places. And I could also cut a piece of the same acrylic tubing to support vertically on the belts. Or I could just accept that I can’t have both? Though I did just scale the fronts to match as if I was going for 22mm thickness and that is not so bad. So maybe I could do that.

This has a 3mm thickness and is at the to scale size. Now to see what I can do with a 2mm thickness.

Leave a Comment

Filed under Uncategorized

Leave a Reply