Pepper Potts as Rescue!!!

This was actually my first helmet project! But I set it aside for reasons soon to become apparent.

Let’s start at the very beginning, a very good place to start.. so you can avoid my mistakes!

sm_P1070215 sm_P1070247

Lumps! A duct tape covered shaped foam ball that actually mimics my actual dimensions. Then the first layer of plasticine.

sm_P1070334 sm_P1070352

Spot the difference. A bit more upward flare to the left as well as more almond shaped eyes, the frown was temporarily in place. If you look closely in the mirror on the right you can see I had shaved the clay back to show a previous layer as it is a different colour.

sm_P1070540

Pretty logical process here: I started sculpting then made a plaster cast and put resin in the two halves.

Great.

Except not. I used paint and oil as mold release… sigh. It would have worked except for the fact that plaster is porous and neither the paint nor the oil had the ability to close them. I would have been fine using a wax or even solid vaseline. Sacrificing the initial mold would have been fine, but this just gripped like a limpet!

So for years the helmet remained stuck in plaster:

sm_DSC_0088 sm_DSC_0089Slowly chipping away at the plaster got most the the RHS free except for the ear buds. And then I decided to try the scientific route! What helps break down plaster? Turns out basic solutions and the safest home method is to dump a whole lot of baking soda in to water and then soak the plaster.

And it works! It took a few days of soaking but here:

sm_DSC_0095 sm_DSC_0096

I accidentally bumped the pieces with my dremel way back before I knew what I was doing… I also flattened a few bumps from bubbles in the mold.

I have tested it on my head and it fits 🙂 The neck hole pinches a little but that is going to be closed over and filled so that I can cut it as needed later 🙂

Next I need to back fill each half with foam and then wiggle them in to place and close the seam. I may tape the whole head and just resin/glass that seam and then back fill.. I’m just not sure. I’d love to make a mold and cast/vacform but I’m not sure I could actually do so. Physically. I know better techniques now so could possibly but it’s the health investment.

 

 

Leave a Comment

Filed under Uncategorized

Leave a Reply